Thanks to Joris van Rantwijk for finding what seems to be
a hardware limitation/bug (bit 28 of the rsamp register being
forced to the value of bit 27).
Signed-off-by: Steve Markgraf <steve@steve-m.de>
This allows to open a device by a name (serial number string)
that has been programmed with rtl_eeprom -s.
Signed-off-by: Steve Markgraf <steve@steve-m.de>
This commit adds the function rtlsdr_set_direct_sampling()
which can be used to enable/disable a mode where the
RTL2832 acts as a direct sampling receiver.
This mode disables the tuner, and by attaching a long
wire, or better, a 50Ω to 200Ω transformer and a lowpass-
filter to the In-phase ADC input (pin 1 or 2 of the RTL2832,
whereas pin 1 is at the molded dot) it is possible to listen to
shortwave radio stations. The coupling capacitors can be
left in place, but for better results they should be removed.
Tuning in this mode is done with the DDC, and since the
ADC samples with 28.8 MHz, tuning is possible from 0 to
28.8 MHz.
Signed-off-by: Steve Markgraf <steve@steve-m.de>
This adds rtlsdr_set_agc_mode() to enable/disable it.
Thanks to Leif Asbrink for finding this setting.
Signed-off-by: Steve Markgraf <steve@steve-m.de>
This tool allows to check for lost samples (and thus check the USB
connection), as well as benchmark the Elonics E4000 tunable range.
(-t switch)
Signed-off-by: Steve Markgraf <steve@steve-m.de>
Usually both, the RTL and the tuner ICs use the same clock. Changing the
clock may make sense if you are applying an external clock to the tuner
or to compensate the frequency (and samplerate) error caused by the
original cheap crystal.
This commit covers all tuner drivers except of the Fitipower FC2580
